These fit the Omega cal. 500 series as well as many others. Perfect fit for the Omega dials on this same page. These are shiny silver or chrome color with black insides. The second hand measures 15 mm from end to end. The minute hand measures 12mm and the hour hand measures 9 mm. These are only sold it sets of 6 pieces 2 of each. Price $20.00 per set of 6 pieces.

Available in white face with applied shiny markers and they have a date. These are perfect and may be refinished but if so they are much nicer than originals I have seen. Measures 29.3 mm across. I have about 20 pieces to sell. These are very nice.

Omega Constellation stainless steel case. Mint condition these have crystal and crown. They have all the Omega markings inside and out and have screw on back. Measure 34 mm across not counting the winding crown and 43 mm lug end to lug end. 12 pieces available.

Elgin Dials with hands. Never used and perfect. Just don't have the time to do this one either so how about you taking on this task. Find Elgin's and put these new old stock dials and hands on them to make them perfect. These are just the way they came from the Elgin factory and are mounted on a plastic piece to keep them together. You cannot have a dial refinished for as nice as these for $20.00 and these have new hands too. When ordering separately please use the number 1, 2 or 3 unless you order all 3. #1 is white textured Lord Elgin 25 jewel with dial feet at 12 min. past the hour and the other at 9 O'clock and it measures 28.7 mm from side to side. #2 is the flat silver dial with markers not numbers and the markers are silver except for the 12, 3, 6 and 9 which are yellow gold. This one measures 29 mm from side to side and has the feet at same numbers. #3 is also silver 25 jewel Lord Elgin with silver numbers and hands and feet positions in the same place as the first one. You can but this separately for $12.00 each or all 3 for $33.00 + shipping.

These were made to fit 12’s Elgin watches and one will fit on the one with the seconds at 6 o’clock for open face movements and the other was made to fit on hunting case movements with the seconds at 9 o’clock. They both measures 37 mm from side to side.

Please specify in the comments section which dial you want to order according to second hand position.

This is a perfect original dial and the scan may look lighter at the bottom but that is the scan it is perfect print and no scratches. Has never been on a watch either. Silver with black print. It measures 28 mm from side to side and the feet are at 18 minutes past and the other is at 52 minutes past.

Set Lever parts for Patek Philippi and IWC. Here are 2 hard to find parts in sealed packages. Both are new never used and genuine Bestfit parts. Price for both parts only $59.00 + shipping

Fine Quality. Black leather-like covered 3 watch valet. Inside of box is covered in tan suede material and will hold at least 3 of your treasured watches. When at a watch show I have displayed 6 smaller watches at a time. Clasp is a magnet to keep it firmly closed. Box measures 7 x 4½ inches and is 3 inches deep.

Here is a lot of scarce parts, 2 pieces Piaget 6 Pl balance staff #1442, 2 pieces Movado 395 winding stems, 2 pieces pocket watch balance staff for Record cal. 433, 3 pieces LeCoultre 11LO winding stem, 1 piece Vacheron Constantin cal. 499 winding stem and finally 1 piece Regulator screw for Hamilton Cal. 992B. This lot I will sell for $99.00 + shipping.

This 3 register movement is a good project for a watch maker or a good parts watch if you know what it is. There is no name on any of the parts but it looks like it is about 18 movement that is not running and needs repair. Has a good balance with hairspring but broken staff. White porcelain dial with black Roman numerals, second indicator at "6", date indicator at "3" and day indicator at "9". There is a small chip at the edge of the hole for the day hole but not bad. Measures 45 mm. from side to side. Cir. Not sure so guess early 1800's.